I will post a picture when I get home.
I reinstalled the stock print head because I found a couple of reels of 3mm PLA I want to use up but will put the K8203 back on when I’m done with those.
Cura yes I did get it setup.
However I run my printer off of a Raspberry Pi with Octoprint.
With this setup I have a webcam on it so I can watch and control the printer from my phone.
I did not set it up to go through my fire wall because if I am not at the house I do not want it running.
I am currently setting one up for my K8400 and hope to have it done this weekend.