Z-axis regulation screw-minor improvement :-)

K8200 3D Printer K8200 - Your printer, creations, and ideas for imp
1

I found it very hard to get the Z-axis regulated with the screw. I therefore turned it around to get good and accurate acces to the screw with my screwdriver. I have added a stopscrew at the end to be sure it hits the microswitch when comming down.

2

That’s nice - probably a picture wouldn’t be a bad idea, thought.

~ Tectu

3

Turning the screw was a good idea.

In addition to that I recommend to exchange the little black plastic piece with this one: http://www.thingiverse.com/thing:229328 and replace the toothed washer + nut with a little spring.