I have now build and testet my new Vertex 8202 3D printer
And it is working fine after adjusting bearings.
But Vertex homepage vertex3dprinter.eu/support/downloads/vertex only give access to
Vertex-m1-v1.4-h1 firmware! If trying downloading dual h2 firmware it only change homepage?
Dual extruder firmware is NOT able to download!
Only old version dual version is able downloading. And this version have failures in extruder feeding!
So please give me access to dual firmware Vertex-m1-V1.4-h2 on Vertex homepage?
Hello ,
i sent you a mail , i joined the file
jean-michel
[quote=“KERGUELEN”]Hello ,
i sent you a mail , i joined the file
jean-michel[/quote]
Thank you very much.
I have now installed Dual extruder h2 firmware and it is working.
So I also hope that Vertex on their homepage will have dual version 1.4 for downloading?
Ole
Hello,
I have the same problem
Please, can you send me the firmware by email.
Best regards
Roberto
[quote=“Robertux”]Hello,
I have the same problem
Please, can you send me the firmware by email.
Best regards
Roberto[/quote]
Please comtact me on mail and I will send you the file.
Ole