Velleman K8090 Relais-Board - Missunderstood?

Hello at everyone…

I bought a K8090 Kit and with the Demo-Software, everything works fine…

My Intention was to programming the Relais as following:

Only K1…K5 are needing.
By closing a contact, a Loop will start:
K1…K5 will close each for 30seconds, first K1 for 30 seconds, AFTER this, K2 for 30 seconds and so on.
Thought I can program this via USB, after this, the Card will do this automatically without any Connections to usb…

As written, with the Demo-Soft I can switch on any relais, even for 30s and after this it will turn off.

But how can I progamming the card as needed?

Maybe it couldn´t programm like this ?

Thx for Answers

Martin from Germany

The card needs to be connected to the PC constantly to run your program.
You could make a mini PC(raspberry pi) and run software from that.