Hey everyone,
I’m uploading the new firmware on to the printer, but when I’m in the arduino IDE, the following warning comes up when I click upload:
avrdude: stk500v2_ReceiveMessage(): timeout
Can anyone help?
Hey everyone,
I’m uploading the new firmware on to the printer, but when I’m in the arduino IDE, the following warning comes up when I click upload:
avrdude: stk500v2_ReceiveMessage(): timeout
Can anyone help?
Hi,
I’ve only a bit of experience with uploading but I did get a similar error when my printer wasn’t correctly connected.
Have you checked you’re using the correct com port and board type?
Milo
I have selected the right board and am using the correct com port as well… I also have the correct USB driver installed on to the PC - but it just won’t upload on to the chip…
Did you put the jumper on the JPROG pins?
They were in originally… I have tried it on my laptop and there wasn’t any problem with the uploading at all… I think that it doesn’t like my main PC…
Thanks everyone for the advice.