Too much spaced lines printed

Have been struggeling a bit today, where I can find the option for make the lines closer eachother with curaengine and repetier host 1.0.6.?
I have a 100% standard k8200.
There areso many options and I start to get confused.
Im asking this because my creations today appeared with a gap between the lines that i dont like.
This happend also with the support bed…

Thx

[quote=“Bigskill”]Have been struggeling a bit today, where I can find the option for make the lines closer eachother with curaengine and repetier host 1.0.6.?
I have a 100% standard k8200.
There areso many options and I start to get confused.
Im asking this because my creations today appeared with a gap between the lines that i dont like.
This happend also with the support bed…

Thx[/quote]

Not K8200 related but still very usefull:
http://support.3dverkstan.se/article/23-a-visual-ultimaker-troubleshooting-guide