Support for the power supply

K8200 3D Printer K8200 - Your printer, creations, and ideas for imp
1

Moving the printer and the power supply hanging around was not nice.
So my first design ever in 3D was a power supply support.
Used TinkerCad for it that is real easy to learn and use.
With 2 remaining M5 nuts and 2 M5 screws (2 cm) it’s a easy fix behind the Z motor.
3 zip-tie’s finish the build.

691×518

691×518

691×518

You can find the design at Thingiverse

2

Hi

I dont know how you did, my DC cable is too short…

3

Strange, more then long enough here.
Even had the filter inline.
Probably different power supply’s in the boxes.

You can always extend the cable… Maybe put a small connector box under the support design for it :wink:

Succes with the mod and you printer.