Step 18

K8200 3D Printer K8200 - Assembly and user manual
1

I need help with the step 18 assembly. I’m confused on how the bed was installed. I need help!!!

2

Step 18 from what chapter?

3

Thanks Vell337. I already figure out how to assemble the part on step 18. But I still need help. Do you know any service technician in California? Or somebody to help me ?

4

Hi Jeffrix123077,

could you describe where you need help? Any particular step of the building or printing process? Or something more general?

Cheers,
kuraasu

5

Relax, take your time, and when in doubt, just ask here

6

Ok I’m finished with the k8200 assembly, download the repetier software .
My computer and the repetier software recognize the printer but unable to run the printer. What did I do wrong?

7

Hi,

Go into the printer settings.
Make sure Reset on Connect is set to Disabled.

8

Hi. Do you know service technician in California?

9

[quote]My computer and the repetier software recognize the printer but unable to run the printer. What did I do wrong?[/quote]I’m sorry but this tells us absolutely nothing…

Post a clear description of your problem

We do not have field technicians or telephone support

10

sorry but my problem are everything and I need someone to be “physically” inspect and repair my printer.

11

Our TX based office can offer inspection/repair.
You can reach them at (817) 284 77 85

12

Hi Jeffrix123077,

the K8200 is an open source printer, and part of the RepRap project. There are many local user groups in the RepRap community, several of them also in California, as far as I can see.

Cheers,
kuraasu

13

Try Yellow Pages, Google…