Slicer infill learning/sharing

Vertex 3D Printer Vertex - Your printer, creations, and ideas for im
1

Hi I didn´t know where to put this but I wanted to share my experience about infill %.
The only different is infill %.

On the top it is 100% and don´t fit together not even with “allot” of force.

wU31EWD.jpg680×1096

On the bottom it is 50% and fit snuggle together.
Feel free to share your experience.

(Item thingiverse.com/thing:591)

2

100% infill is known to deliver too much filament. It’s recommended to stay under 60% (for various reasons already commented elsewhere).