Removing Ooze Shield parts

Vertex 3D Printer Vertex - Printer software (repetier, slicer, ...)
1

Hi,

I’ve put a link to a picture of an object i’m trying to print with two colors. The parts circled in red and with the arrow keep getting stuck to the inside of the semicircular shape during printing.
I believe these parts are associated with the ooze shield but I was wondering if anyone knew if it was possible to remove just these small circular towers and keep the outside ooze shield?
I know I can turn off the ooze shield in Cura but I would like to keep the main shield there for obvious reasons.

https://www.dropbox.com/s/kvzwbupy2x9f6q2/3dPrint.png?dl=0

Any help appreciated!
Thanks,
Milo

2

Those small towers are part of the oozing shield (Repetier is trying to set an oozing shield at the same distance of all walls). As there isn’t any setting for the oozing shield you can’t set it a bit farther from your object.