Problem with Temperature and Software

K8200 3D Printer K8200 - Issues while printing
1

Hello,

Heat Extruder and Heat Printbed are not hot, if i set 400°C and 300°C. . Wrong wired? I didn’t used MULTI-COLOURED FLATCABLE. I used 0,14mm² Cable.

And software problem. K8200 Repetier-Host V0.95F

But Motor works, if i set Home-Button.

Greeting
DEAFBOY80

2

You need to set a temperature lower than the maximum temperature in the firmware (I think 275°C)

In your case, the firmware send an error of temperature and a security desactivated all heaters (bed and extruder)