I tried to install a PCG10 Generator with PcLab2000SE on a system running with Win 7 64 Pro.
Driver is not implemented by the SW (LPT1).
Any advises step by step how to run installation successfully?
Thanks a lot.
From what I have read on here the PCG10 will not run on x64 operating systems.
The PCG10 does require a native LPT port unfortunately most systems do not come with this.
Thank you for your response.
The docking station delivers me a native LPT port.
But there must be any inconsistency in driver SW.
Therefore I get the message “Could not open the DriverLINX Driver”.
I run the driver implementation, no success.
Best