I have trouble with my new filament. It is hard to get it to stick. The corners peel up and I even get some layer shifting. I never got it this bad and I was fiddeling with the first layer height and first layer extrusion width. My first layer height is 0.3 mm and my extrusion width is 140% (of 0.5 mm). I upgraded my printer with a leadscrew and I am printing with 0.2 mm layer height.
I set my temperature at 190 for the extruder and 50 for the heated bed. It seems to be extra bad with this particular print.
My settings:
Pictures of the part: