Hi
I have a little question, I have the K8200 printer and works fine.
I have must install newest software (new laptop) , repeater, slic3r and normally, when the bed has is temp, the extruder go to his Home position, he than is warming up, after that before he’s printing he fill some extra filematerial on the bed.
But now, after the bed is warming up, the goes to Home position and think 2 mm go to upstairs, wait when extruder has his temp goes to printing the 3D model.
Where I can change the setting so he’s fill some material first, before hes printing the model?
Thanks Allot