Hi!
Hello! I updated the firmware on my VM208 now I can’t reach it. A page with the following text pops up, “This is out captive portal front page. You were trying to reach: http://192.168.1.37/ Try opening this link instead”
Can I do a reset of it, or is there another solution?
Hi @checker,
By performing a Firmware upgrade, the VM208 is set back to DHCP mode.
The IP address may have changed as a result.
Check via the software discovery tool: https://www.velleman.eu/downloads/files/downloads/vm208_software.zip,
whether the module is detected in the network.
Normally the correct IP address is also displayed there.
It can also be found in the router DHCP client list.
Best regards,
Velleman Support