Filemanet load issues

Hello,

I bought the printer (K8400) 3 days ago and it’s my first one, obviously I’m having some trouble :slight_smile:
After 2 days of assembly, I had a lot of difficulties trying to aline the axes in a way that does not produce the loud ‘BRRRR’-noise. I got this (mostly) sorted out right now.

The next step is loading the filament, here I’m having a problem with the heating. The temperature on the lcd rises to about 170 at a pretty steady rate, after that it sometimes increases to 175 and drops back down to 170, rises again, drops again…
I waited 10-15 minutes and then decided to unplug the machine to avoid damage to the printhead (in case the fault lies with the temperature sensor).

Does anyone have any advice/help for me?

Kind regards

Well as you stated check if the temp sensor is properly placed.
Also check if the heater connector is properly seated on the main board

I moved the sensor a tiny bit, this solved my problem!