Am I the only one who thinks that the failsafe acceleration values are just a bit too high? Considering that the pulleys are not the best quality and with only one screw in them, I would say that the acceleration should go down a notch (and yes, I have already lowered them myself, but still). What do you think?
With correct calibration of the X & Y rods our printers are perfectly capable of printing with these acceleration values. We have not experienced slipping pulleys on our printers but we are looking for a solution for people who have this problem. You can however lower the standard value, you could experience a bit more stringing due to the lower start-speed when traveling and curling of the edges with small objects.