Error please power cycle

Hi, help !!

1° after 75% of the print I got a message on the info screen: please power cycle. What can I do?
2° how can i resume the printing where it stopped?

thx for the advise!!!

Hello Frank Hermie,

If the message “Please power cycle” is shown on display there’s something wrong with hotend PCB.
More specifically the gyroscope sensor (tilt) on hotend PCB.

You can create a ticket here to get the spare part.

It’s not possible to resume the print, after a power cycle. That’s not implemented in current firmware version.

Best regards,
Velleman Support

Thank You for delivering the gyroscope sensor for free!!

You’re welcome.

Nice to hear that You’ve received the part correctly.

We wish you lots of printing pleasure. :slight_smile:

Best Regards,
Velleman Support