Hello everybody
I’m new to this and I just bought a K8400, it’s installed and everything seemed to work, except when I tried to print something it didn’t work. I only got the message ‘ERR:MINTEMP’
I know this can have a few options why this message is put in so I already did the following things:
- installed the firmware for 1 nozzle instead of 2
- Checked the heating sensor (gives about 120K ohm)
- checked cables
And it gets to 210°c and is able to cool down but the messages doesn’t disappear.
I even put a new sensor in it to be sure (have one for a second nozzle in the future)
I did however uploaded the software from arduino 1.6.9 (heard people saying it might not be good)
However when i check on my system it does say 1 nozzle.
For now I don’t really know what to do? Since I’m new to it, I don’t like to open everything up and perhaps make everything worse.
Anyone got an idea of what the problem might be?
Many thanks!
Greetings
Casper