I was unable to get Project 9 Light Switch to work following the manual.
Project manual say’s HEDU01-2011-ED1-rev.1 on backside.
I could get the circuit to work changing around a little,
but I wonder if the one in the manual works for anybody else or if it indeed is faulty ?
Should work fine as is.
Did you orient the breadboard correctly?
Sorry, this forum does not allow picture uploads
If you can provide LINKS (e.g. by using a free online picture base) to HI-RES and SHARP pics of your assembly
then we can take a look and provide some feedback.
I made a miss take and used two 100 K resistors instead of one 100 ohms and one 100 K ohms.
Best regards,
Karl