Thanks für your reply.
I have no gcode file genereted. The Problem is also bevor you run the file, when I use to control the printer manually or by manual gcode-inputs.
When I run a dcode-file, the echo-message is the same like by the manual input.
- I connect the printer (echo: firmware etc…, connection is OK)
- I give manually a gcode or push on the button to move Z+ or another axis
- N24 G1 Z1 F100
- ok
- echo: too long extrusion prevented
For me it looks like an firmware or board-error. Is it possible to load a “modificated” firmware for testing ?
Do you need any gcode file yet ?