Drillingmachine

What do I need to control a (homebuild) PCB drillingmachine from my PC?
The machine consists of 2 steppermotors for the X and Y direction and I need a pulse to start the drillingsequence.
Who can help?

I think it was better to post this in the “PC-related”-forum.

Use an interface:

K8000 (for steppermotor and start/stop pulse)

And use a steppermotorcard:

K8005 (Via I2C of the K8000) x2

Thank you Tom.
Your right about the forum, but you answered my question already.
I will buy a K8000 and see what it does. The K8005 is a little bit too light for the steppermotors I used.