Hello, I really like curaengine software, but lately im struggeling with the numbers…
My creation are not coming out nice,and I really dont know how to improove the prints…
I got a curaengine setup from some of you, but of course mine is an 100% original printer and cant find a good setup.
Is there someonelse struggeling like me?
If you guys say I can post my actual settings
Looking for suggestions, thx.
This is a very old link so I think it is for a very old version of the software.
I was using Cura a couple of years ago but went back to the original slicer because of more options.
Try looking at this link.
http://forum.velleman.eu/viewtopic.php?f=50&t=10749&p=44475&hilit=cura#p44475
[quote=“Wrong Way”]This is a very old link so I think it is for a very old version of the software.
I was using Cura a couple of years ago but went back to the original slicer because of more options.
Try looking at this link.
http://forum.velleman.eu/viewtopic.php?f=50&t=10749&p=44475&hilit=cura#p44475[/quote]
I know this post, thx, that exactly where i took the settings,I started from there…
Could you post a picture of one of your projects that did not turn out?
I havnt took pic yet, I willsoon.
Basically when the printer print first 2 layers is fine, then there is a lot of plastic that come out from the nozzle screwing up the project, is like there is an overabundance of pla… I tried to reduce the flux but doesnt change…
Thats why i was curious to try with someone profile, possibly with a standard k8200 like mine…
You should really start with 0.95F that was customized for the K8200 to make sure everything is working properly before you make changes.
Oh yes i did, for a week, but the precision and the faster print brang me to curaengine world.
