Controller Board Mounts - Not as per the manual

g4ugm · February 9, 2015, 6:20pm

Folks,

I only seem to have the long spacers in the Controller Board mounting bag and no “plastic rings”.

I note some one else has had issues where the short plastic rings would not fit properly here:-

so have they been removed? If so is there a change history or errta file any where?

I assume the screws should not go in so far as to touch the vertical rail? For now I have fitted washers from my general spares box…

Dave Wade

HLH · February 10, 2015, 4:37pm

Hello,

There were no “plastic rings” in my Controller Board mounting bag too, but I found them inside the package containing the Controller Board itself.

They are just neat “top hat” spacers to keep the screw from touching the circuit board. Mine are a tight fit; I squeezed them in carefully with pliers.

HLH

g4ugm · February 10, 2015, 11:48pm

Thanks for that, found and installed. They are a tight fit, so I used pliars too…