Connect a Motor Mots2 to a plate K8096 with USB interface

Modules General
1

Hi
next week we buy a mots2 and a K8096 … now we have one problem. The mots2 has a connection with 6
cabels and the K8096 we can only connect 4. I want to know which cabel I need to connect with the plate entrance.

Thank you Very much (sorry for my english)

Mickaël and Kristof

2

Please take a look at this post:
http://forum.velleman.eu/viewtopic.php?f=3&t=9132

3

thanks

But the problem is with the software now, I can not late the motor turn…

thanks a lot
.
Mickael

4

Can you supply more information regarding the problem?

5

So we conected the mots2 on the plate K8096then we are going to the software motordemo. I connect it with USB and after that there is nothing thats gone. normally I think that the motor need to work but it didn’t.

6

Most likely an assembly problem or a problem with the motor wiring.
Sorry, this forum does not allow picture uploads
If you can provide LINKS (e.g. by using a free online picture base) to HI-RES and SHARP pics of your assembly (both solder- and component side)
then we can take a look and provide some feedback.