Access K8201 SD Card from repetier

K8200 3D Printer K8200 - Wiring and electronics
1

I want to make the SD card plugged into the K8201 Standalone controller accessible from repetier.
Can anyone tell me if this is possible?
I know it would require a firmware mod, but i don’t know if it is accessible at all from the controller board.

cheers,

Christian

2

[quote=“ichbinsnur”]I want to make the SD card plugged into the K8201 Standalone controller accessible from repetier.
Can anyone tell me if this is possible?
I know it would require a firmware mod, but i don’t know if it is accessible at all from the controller board.

cheers,

Christian[/quote]

Command back!

I recently found out with repetier 1.0.6 it works right of the box. I just forgot to init the card on the conrtoller …